8. Input/Output devices¶
There are many difference between input devices and output devices from the microcontroller, the following picture shows examples of each type.
Input devices¶
is a piece of equipment used to provide data and control signals to an information processing system such as a computer or information appliance.
Available input devices: Botton, push botton, sensors and switchs.
Output devices¶
A microcontroller can take actions in the world by changing the voltages of its output pins. Output pins typically take on two discrete voltages (usually 0 and 5 volts). Each output pin reflects the value of some bit in the microcontroller’s memory.
Available output devices: Buzzers, servo, indicators, motors and LCD displays.
Connect input, output devices with the microcontroller¶
Research¶
“Lorem ipsum dolor sit amet, consectetur adipiscing elit, sed do eiusmod tempor incididunt ut labore et dolore magna aliqua. Ut enim ad minim veniam, quis nostrud exercitation ullamco laboris nisi ut aliquip ex ea commodo consequat. Duis aute irure dolor in reprehenderit in voluptate velit esse cillum dolore eu fugiat nulla pariatur. Excepteur sint occaecat cupidatat non proident, sunt in culpa qui officia deserunt mollit anim id est laborum.”
“Lorem ipsum dolor sit amet, consectetur adipiscing elit, sed do eiusmod tempor incididunt ut labore et dolore magna aliqua. Ut enim ad minim veniam, quis nostrud exercitation ullamco laboris nisi ut aliquip ex ea commodo consequat. Duis aute irure dolor in reprehenderit in voluptate velit esse cillum dolore eu fugiat nulla pariatur. Excepteur sint occaecat cupidatat non proident, sunt in culpa qui officia deserunt mollit anim id est laborum.”
Useful links¶
Code Example¶
Use the three backticks to separate code.
// the setup function runs once when you press reset or power the board
void setup() {
// initialize digital pin LED_BUILTIN as an output.
pinMode(LED_BUILTIN, OUTPUT);
}
// the loop function runs over and over again forever
void loop() {
digitalWrite(LED_BUILTIN, HIGH); // turn the LED on (HIGH is the voltage level)
delay(1000); // wait for a second
digitalWrite(LED_BUILTIN, LOW); // turn the LED off by making the voltage LOW
delay(1000); // wait for a second
}
Gallery¶
Video¶
From Vimeo¶
Sound Waves from George Gally (Radarboy) on Vimeo.