Week 2 Computer-Aided Design¶
2D design¶
Firstly,inkscape is opened, then we create a circle then a smaller circle inside it.
Then we should have a drawing similar to this.
After that we create two spirals as shown below.
The two spirals are placed in the circle, then another much smaller circle is created as shown below.
This drawing is inspired by the sandscript project.
3D design (tinkercad)¶
Firstly, tinkercad website is opened, then we create a cyclinder as shown below.
Then we create a ball and attach it to the cyclinder as shown below.
Then we create a circle and place it on the cylinder which resembles a track for the ball.
3D design (fusion 360)¶
Firstly, fusion 360 is opened, then we create a 50 mm circle.
Then we create a 45 mm circle inside the original circle.
We extrude both circles to achieve a cylinder.
Then we extrude the inner circle to negative mm and just one mm less than the extruded cylinder.
Now we have a cylinder with a hole.
We used the fillet button to have a smoother look on the bottom side of the cylinder.
Now we create a handle using curve lines.
The problem faced is that the mug handle should be empty from inside and touching the mug.
Week 2 Computer-Aided Design