Material
Name
GR silicon
graffiti resin
(GR resin)
Clear Epoxy Resin - Amazing Clear Cast
Gypsum
Picture
Safety
What not to do
Don’t ingest, inject and absorb silicone in your body.
don't eat,drink,inhale, put on skin or into the eye,
keep away from heat,sparks and flame (for further precautions and what to do if any happened
check the link below)
1-Do not breathe fumes, vapors, mists, or sprays.
2- Do not eat, drink or smoke in the work area.
3- Do not get moisture into containers.
4-Do not make skin or eye contact.
Avoid:
- Excessive Inhaling
- Ingestion
- Eye contact
Processes & Time
The steps to make
Mix part A and B , pour it in a vacuum to extract the air bubbles then pour it in mold to vulcanize.
1- 10 gr of Resin to 6 gr of Hardener.
2- Stir the mixture for 3 minutes.
3- Pour the mixture and spread it over the project.
4-Working time 45 minutes, drying in 24 hours, Full cure within 72 hours.
1- Measure equal amounts.
2- Mix thoroughly.
3- Pour slowly.
Note: Slowly mix and pour resin to avoid air bubbles.
1. It needs to be garnered into water ( Not vice versa) in a clean bucket.
2. Mix approximately 32L of cool, clear water and 40kg Mada plaster together.
3. Stop adding once the powder is exceeding the water level.
4. After 1 minutes of soaking.
5. properly mix by hand or mixer.
Mix Ratio
Even amount according to proportion (1:1).
10:6
About 60% resin
To 40% hardener
1:1 by volume
4:5
4L water
5kg gypsum
Time
Cure
Work
Cure
Work
Cure
Work
Cure
Work
3 -12 hours
30 to 45 minutes
24h-72h
45min
72 hours
30-40 minutes
15 min
5 min
Cured material state
Rubber
solid (not flexible)
Solid, strong and clear
Solid
Information Link
Process pictures and comments
Firstly, I mixed part A with B by adding an equal amount of 7.5g for each part.
Then I added the silicone to the mold.
Finally , I poured another batch with color and glitter.
We first added 10g of resin
Then added 6g of hardener for a total of 16g
Then we poured the mixture into the mold
Firstly, we added 7.6g of “B” side resin in a plastic container.
Secondly, we added 7.6g of “A” side resin in another plastic container.
Thirdly, we mixed them thoroughly.
Finally, we slowly poured the mixture into the silicone mold and let it dry till the next day.
We first poured 8g of water in the container
Then, we added 10g of gypsum powder in another container.
After that we poured the water into the gypsum container
Mix, mix, mix!
Finally, pour the mixture into the silicon mold and let it cure.
Result pictures
This is the result after fully cured within 72 hours.
